This is a HP Signal Generator, 100kHz to 990MHz, unfortunately not very popular with many in the trade, mainly due to design/quality issues. Most discussions around the web talks about issues on frequency stability, harmonics, and the notorious one is attenuator failure.
This came to be from a flea market and as usual, I picked it up without realizing the history behind this model. The part which caught my attention is the clicking you hear when you try to change the frequency or mostly output signal level. I was curious what was making this noise.
There is no repair attempt here at electronics level or component/board level. This is purely documenting the attenuator repair, which I could not find on web. So here it is for all those who wanna know what the heck is that which is making the noise when you change output signal level, what fails, and how to fix it.
Here is a video Explaining the Details –
Reference Picture – with photos of actual components.
Key points to remember –
1. Do not open the assembly with the unit in service position, do keep it upside down and open the A10/A11 assembly and tie it down to hold it up.
2. Keep a small magnet ready, to pick up the steel balls, in case they fall underneath the PCB.
3. The Cam Guide (Cover) – A9MP4/A9MP5 screw needs to be tightened to specific torque. If you over tighten it, the cam will not move, if you leave the loose, the steel balls can come off and the switch contacts will move out too.
4. There are washers on both sides of the screw for the cam Guide (cover) – Part# in Diagram – A9MP4/A9MP5. Both washers (Spring washer and spacer) must be in place, else the cam will not operate/Move.
5. This is a very delicate assembly with lots of tiny parts. Careful disassembly and repair is needed, in a clean bench to locate part in case they fall off.
The solenoid pulling the cams in and out is controlled by a 24V Rail. in case you see the entire assembly dead – ie no movement at all – check the power rail and fuse. There is a SCR used as a crowbar in the circuit as overload protection.
Marking the section of the schematic here, highlighting key fellas. Remember, if the fuse is blown, do not replace until you are sure why it blew up in the first place. This is located on A10 Board.
Thats all for this, all the best